Portable and folding work station with quick opening system. Features a large work surface and can hold up to 180kg. Supplied with 2 x 12" clamps.
Plastic Construction Max.180kg Loading Capacity Quick-Opening System Portable Enables Horizontal & Vertical Clamping
SPECIFICATION Manufacturer Guarantee 1 Year Guarantee Pack Size 1 Pieces in Pack/Case 1 Product Depth 550 mm Product Height 755 mm Product Type Folding Workbench Product Width 850 mm Total Product Weight 12.25 kg
Top comments
Haighy
30 Jun 176#2
Got one of these last year, use it a lot. Dead easy to put up. Sit it on the floor, pull the locking clips, lift up the top and the legs drop down and lock. Sturdy, good size, very clever design. Tempted to buy a 2nd one at this price :-)
ianjury
30 Jun 174#1
I bought one if these i used once and i do not recommend not easy to put up bit clumsy and after using it to cut tiles wood etc a nightmare to clean with all the holes ect i think for me was £40 wasted better off with a b & d workmate
All comments (21)
ianjury
30 Jun 174#1
I bought one if these i used once and i do not recommend not easy to put up bit clumsy and after using it to cut tiles wood etc a nightmare to clean with all the holes ect i think for me was £40 wasted better off with a b & d workmate
furiousjammin to ianjury
30 Jun 172#6
You're doing it all wrong. Nothing clumsy about them. Hold the handle at each end, press buttons and table just "falls" into place and legs pop out. Then just lock the centre support and done.
As for cleaning, use a vacuum, or stand it on its side and use a brush.
dr_joolz to ianjury
30 Jun 171#11
i found my keter unbelievably easy to use (assume Macalister is the same). might not be the most study but great for lots of things including cutting tiles and timber (not too heavy ones) I never bothered cleaning mine just rinse it a little
daverobinson5243 to ianjury
30 Jun 171#14
"Not easy to put up"?? Have your arms been amputated?
Haighy
30 Jun 176#2
Got one of these last year, use it a lot. Dead easy to put up. Sit it on the floor, pull the locking clips, lift up the top and the legs drop down and lock. Sturdy, good size, very clever design. Tempted to buy a 2nd one at this price :-)
leewaterjet
30 Jun 171#3
I'd recommend one of these. Had my 600cc motorbike engine on it with no problems. beer than a flimsy workmate.
Loudmouth
30 Jun 171#4
Workmates are useless next to these. With a little practise these are a breeze to put up and down.
welder299
30 Jun 171#5
easy to put up and easy to pack away. saves loads of space in my man cave
summerof76
30 Jun 171#7
Good deal, heat added
Predikuesi
30 Jun 171#8
£45 in B&Q, so good price.
Roger_Irrelevant
30 Jun 172#9
As ianjury pointed out, these can be clumsy to get down cos inevitably bits of sawdust etc. will get stuck in the recesses so you can make the mistake of forcing it to close.
- Always hose/vacuum it off fully before folding away
- the plastic hinges on the legs are EXTREMELY brittle, but they are put under huge load if you fold it away wrong. On on my first one literally went bang and shattered.
Opening post
Plastic Construction
Max.180kg Loading Capacity
Quick-Opening System
Portable
Enables Horizontal & Vertical Clamping
SPECIFICATION
Manufacturer Guarantee 1 Year Guarantee
Pack Size 1
Pieces in Pack/Case 1
Product Depth 550 mm
Product Height 755 mm
Product Type Folding Workbench
Product Width 850 mm
Total Product Weight 12.25 kg
Top comments
All comments (21)
As for cleaning, use a vacuum, or stand it on its side and use a brush.
- Always hose/vacuum it off fully before folding away
- the plastic hinges on the legs are EXTREMELY brittle, but they are put under huge load if you fold it away wrong. On on my first one literally went bang and shattered.