Arc Welder for 39.99 with a three year warranty from Lidl. They also sell the welding electrodes for 2.99
Pretty decent deal considering some spend far more for a Welder
Also comes with the accessories such as the shield , shoulder strap, chipping hammer with wire brush
Top comments
jamgin
5 Jun 176#8
Yup. An Ark welder.
backinstock
5 Jun 174#1
Thanks, I'll get one for the wife to use.
Latest comments (26)
marty-401
6 Jun 17#26
It was the barn shaped on I saw. They did a rectangular one prior to this of a slightly lower output.
Anthonis
6 Jun 17#25
Been in lidl today seen those but I think on the box it said from 30-80A so maybe its different product now?
marty-401
6 Jun 17#24
I remember looking at the box on the shelf, it said something like 75 to 100amp welding current range. Meaning its going to be difficult on very thin (car body type) material and naff all penetration on anything over 2mm thickness. You would be limited to 1.6mm to 2mm welding electrodes of 6018 type (as the open circuit voltage of the welder won't strike an arc on any rods requiring mlre than 50v ocv). The duty cycle from cold will let you weld about three 2mm electrodes, after each thermal intervention you could just about weld one more rod after waiting 10 minutes each time.
It's enough go give you arc eye but little else in return for £40.
Maybetyrone
6 Jun 17#17
U buy rubbish tools lidi U do not buy a welder here is every one on here stupid weld with the dam thing 10 minutes it cuts off wait 30 minutes then to cool and start again
dirtynoodle to Maybetyrone
6 Jun 17#19
It's £40. If your building some gates/fencing for home a 10 minute run time isn't too bad. It'll still save you a fortune over paying someone else to make them for you.
bobo53 to Maybetyrone
6 Jun 17#20
not the top quality tools but same priced tools from a different make are crap proportionally. 10min. continuous welding it is a lot and during pauses is got plenty time to cool. my very cheap old welder switches off for a max of 5 minutes but rarely and depends what I do
jimhuf to Maybetyrone
6 Jun 17#23
you must be new here, a well priced turd in a box goes hot here
jaydeeuk1
6 Jun 17#22
Decent price, cheaper than a couple of car batteries in series and probably does a better job.
tflis007
6 Jun 17#21
It's a leftover from about 3 weeks ago.
ray1066
6 Jun 17#18
Ark welding is a skilled job. Don't underestimate the difficulty particularly on car gauge steel. Down hand on heavier gauge is a possibility but not structural.
londonguy
6 Jun 17#16
great for a cut and shut
jamhops
5 Jun 17#15
Pretty poor post, repost valid by a day and people will look for limited left over stock...
Opening post
Pretty decent deal considering some spend far more for a Welder
Also comes with the accessories such as the shield , shoulder strap, chipping hammer with wire brush
Top comments
Latest comments (26)
It's enough go give you arc eye but little else in return for £40.
Ps. It's still a naff piece of kit..
http://www.mig-welding.co.uk/forum/threads/parkside-arc-welder-lidl.33479/